Metasequoia Workshop Part 3:

The Wing

In the last part of the workshop we have created the airfoil. Now we build the complete wing. At first we change to the top-view (F2):

Now we elongate the cuboid (X-Axis):

When the cuboid has reached the correct size we cut it with the "Knife". This is depending on the shape the wing will have.

Now we mark the points and downscale them in all axis.

Tipp: Write down the numbers and move the points for the left wing to the same values. Then they will be equal.

Now we move the last points until we get our desired shape of the wing.

In case the wing should get a dihedral we do the following:

1. Mark the points that are aloft.

2. Rotate them in the Z-Axis (remember the number of degrees)

3. Move these points to a higher position

Now our wing has a dihedra: